|
SERPENT 733 Pro Nitro Racer for Serious competitive racing!
THIS IS A PRO CAR KIT!
About the car:
Serpent 733 Serpent 200mm racecar with 4-wheel drive, 2-speed gearbox, independent suspension. Low center of gravity. Newly developed geometry and weight balance. High cornering speeds. Superb braking. Easier to race, with wide sweetspot. Very light and responsive steering. High quality nylon and precision machined alu parts. Serpent Spring ( SS) steel transmission parts. Centralised mounting of all electronics. Easy to build and very open design for easy maintenance. Developed, engineered and tested by Michael Salven, in close cooperation with Team Serpent drivers. Serpent, the racing experience Introduction late july 2009.
Serpent 733, new design approachThe Serpent 733 has a new, very distinct open design and sets new standards in 1/10 scale race-chassis design.
Many innovative and practical solutions are build into the unique design, to make assembly, set-up, racing and maintenance a joy ! New geometry and roll-centers, lower center of gravity and modified weight-positioning for improved grip and better balance.
Adjustable caster, camber, toe-in, width, wheelbase front and rear, ride-height, roll centers and more.
Alu front lower bearing blocks and suspension brackets, with integrated anti-roll bar holders and integrated alu middle bearing block. The gear-diff is seated in eccentric nylon bushings to set the belt-tension. The right position ( choice of 4) of the eccentric bushings can be recognised from the outside, for easier re-assembly. The lower front end brackets have steel pins pre-mounted which slide into the slots in the chassis, for precise positioning.
Very open design split type rear end assembly. The supersmall and light gear-diffs mount very low in the car, in precision machined split type alu brackets. The gear-diff is seated in eccentric nylon bushings to set the belt-tension. The right position ( choice of 3) of the eccentric bushings can be recognised from the outside, for easier re-assembly.
The lower rear end brackets have steel pins pre-mounted which slide into the slots in the chassis, for precise positioning.
The very open design leaves lots of space for maintenance, cleaning and cooling.
The 3mm chassis is made of precision machined aerospace quality 7075 T6 alu. Countersunk and with chamfered edges. Some extra machining where needed for the belt, the engine with airscoop for cooling, for the flywheel and some extra space to allow the moutning the transponder below the fueltank. 
The very closed design of the chassis creates the right level of rigidity in the car. More flex-control is offered with the alu stiffners on the chassis.
A laser-angraved logo is the finishing touch.
The very closed design of the chassis creates the right level of rigidity in the car. More flex-control is offered with the alu stiffners on the chassis.
A laser-angraved logo is the finishing touch. And Many More features!
go to the Serpent Site for full Features and more!
http://www.serpent.com/product/804000
Kit Does NOT Include the following:
* Tyres
* Body
*Radio and Receiver
* .12 -.15 Motor
* Batteries
$675.00
$630.00
|
